Technical Support

Home > Technical Support

2. What do the Parameters for the thermoelectric cooling module mean?

 

I

Operating Current to the TEC module (in Amps)

Imax

Operating Current that make the maximum temperature difference ?Tmax (in Amps)

Qc

Amount of heat that can be absorbed at the cold side face of the TEC (in Watts)

Qmax

Maximum amount of heat that can be absorbed at the cold side. This occurrs at I = Imax and when Delta T = 0. (in Watts)

Th

Temperature of the hot side face when the TEC module operatiing (in °C)

Tc

Temperature of the cold side face when the TEC module operating (in °C)

?T

Difference in temperature between the hot side (Th) and the cold side (Tc). Delta T = Th-Tc (in °C)

?Tmax

Maximum difference in temperature a TEC module can achieve between the hot side (Th) and the cold side (Tc). This occurrs (Maximum cooling capacity) at I = Imax and Qc = 0. (in °C)

Umax

Voltage supply at I = Imax (in Volts)

η

TEC module cooling efficiency ( %)

α

Seebeck coefficient of thermoelectric material (V/°C)

σ

Electrical coefficient of thermoelectric material (1/cm·ohm)

κ

Thermo conductivity of thermoelectric material (W/CM·°C)

N

Number of thermoelectric element

max

Current attached when the hot side and old side temperature of TEC module is a specified value and it required getting the Maximum efficiency (in Amps)

 


上海11选5前三走势图 股票分析报告2020 上海快3官网下载 股票分析中国银行-历史交易数据-收盘价 中国最大的股票配资平台 甘肃十一选五和值表 海南环岛彩票开奖结果 中信证券股票分析软件 体彩陕西十一选五开 万达彩票高手论坛 快乐十分钟奖金规则 十一运夺金软件破解版 到百度首页 湖北快3走势图一基本走势 赌博每天赢500赢了5年了 福彩好彩1 山东11运夺金下载